Insulation Resistance Check

Test voltage, minimum IR and polarisation index

Design data
MΩ
MΩ
MΩ
Settings & basis
ResultPreliminary · verify before design
Minimum insulation resistance≥ 1 MΩTest at 500 V DC
Within limit150 MΩ passes
Test voltage500 V DC
Polarisation index (IR10 ÷ IR1)Enter 1 and 10 min readings

Disconnect or protect sensitive equipment (surge devices, electronics) before testing. New installations normally read far above the minimum; a low but passing value often points to moisture or damage. PI ≥ 2.0 is a common acceptance for motor and transformer windings (IEEE 43); follow your specification.

What to verify before design ↓

Verify before using in design

  • Follow the specification's own minimums where they are higher; MV equipment uses the maker's and the specification's values.
  • Check the edition of each standard that your project specification calls for.
  • Confirm with manufacturer data and the approved design before construction.
Basis & methodVersion 1.0 · Nov 2026Basis last checked: Oct 2026✓ Tested against worked examples✓ Reviewed by an electrical engineer · Nov 2026

Formula

Minimum IR per IEC 60364-6 Table 6A PI = IR(10 min) ÷ IR(1 min)

Standards and references

  • IEC 60364-6:2016 Table 6A (minimum insulation resistance)
  • BS 7671:2018+A3:2024 Table 64
  • IEEE 43-2013 (polarisation index for rotating machines)

Assumptions

  • Minimum values for low-voltage installations: SELV/PELV 0.5 MΩ at 250 V DC; up to 500 V 1 MΩ at 500 V DC; above 500 V 1 MΩ at 1000 V DC.

Inputs and units

Circuit—
Measured IR (lowest reading)MΩ0.01–100000
IR at 1 min (for PI, optional)MΩ
IR at 10 min (for PI, optional)MΩ

Typical range: last column

Worked example (default values)

  • CircuitUp to 500 V (e.g. 230/400 V)
  • Measured IR (lowest reading)150 MΩ
  • IR at 1 min (for PI, optional)0 MΩ
  • IR at 10 min (for PI, optional)0 MΩ
Minimum insulation resistance≥ 1 MΩ150 MΩ passes

Next steps

More Electrical calculators

Found an error? Tell us

Describe the problem briefly (the wrong value, the right one, and the reference if you have it). The page name is sent automatically.