Bearing Capacity (Shallow Footing)

Ultimate and allowable bearing pressure

Design data
kPa
°
kN/m³
m
m
m
Settings & basis
ResultPreliminary · verify before design
Allowable bearing pressure (gross)342 kPaUltimate 1,026 kPa ÷ FoS 3
Nc · Nq · Nγ30.1 · 18.4 · 22.4
Shape factors sc · sq · sγ1.61 · 1.58 · 0.60
Overburden at base q27.0 kPa
Effective γ below base18.0 kN/m³
Allowable load on footing1,367 kN

Preliminary check with vertical central load and level ground. Settlement often governs the allowable pressure, especially on sand and soft clay.

What to verify before design ↓

Verify before using in design

  • Check settlement: it often governs allowable pressure (typically 25 mm for isolated footings on sand).
  • Use the geotechnical engineer's recommended bearing value where one is given.
  • Eccentric or inclined loads, slopes and layered soils need a full analysis.
  • Check the edition of each standard that your project specification calls for.
  • Confirm with manufacturer data and the approved design before construction.
Basis & methodVersion 1.0 · Nov 2026Basis last checked: Oct 2026✓ Tested against worked examples

Formula

qu = c′Nc·sc + q·Nq·sq + ½·γ′·B·Nγ·sγ Nq = e^(π tanφ)·tan²(45°+φ/2) Nc = (Nq−1)cotφ Nγ = 2(Nq+1)tanφ

Standards and references

  • EN 1997-1:2004 (Eurocode 7), Annex D
  • Vesic (1973) bearing capacity and shape factors
  • BS 8004:2015+A1:2020

Assumptions

  • Vertical central load, level ground, no inclination or depth factors.
  • Gross allowable pressure = ultimate ÷ factor of safety (often 2.5–3).
  • Soil parameters are design values from the geotechnical report.

Inputs and units

Cohesion c′kPa
Friction angle φ′°20–42
Unit weight γkN/m³14–23
Foundation depth Dfm0.5–4
Footing width Bm0.6–20
Footing length Lm
Footing type—
Groundwater—
Factor of safety2–3.5

Typical range: last column

Worked example (default values)

  • Cohesion c′0 kPa
  • Friction angle φ′30 °
  • Unit weight γ18 kN/m³
  • Foundation depth Df1.5 m
  • Footing width B2 m
  • Footing length L2 m
  • Footing typeSquare / rectangular (uses L)
  • GroundwaterDeep (below B under the footing)
  • Factor of safety3
Allowable bearing pressure (gross)342 kPa

Next steps

More Geotechnical calculators

Found an error? Tell us

Describe the problem briefly (the wrong value, the right one, and the reference if you have it). The page name is sent automatically.