Excavation Volume & Trucks

Sloped pit volume, bulking and truck loads

Design data
m
m
m
%
m³
ResultPreliminary · verify before design
Bank (in-situ) volume1,044.0 m³Loose volume 1,305.0 m³ after 25 % bulking
Top opening26.0 × 18.0 m
Truck loads (loose)82
Base area240.0 m²

Typical bulking: sand 10–15 %, clay 20–40 %, rock 40–60 %. Batter angles and support must come from the geotechnical report and temporary works design.

What to verify before design ↓

Verify before using in design

  • Safe slopes and support come from the geotechnical report and temporary works design.
  • Check groundwater level and dewatering needs before excavation.
  • Check the edition of each standard that your project specification calls for.
  • Confirm with manufacturer data and the approved design before construction.
Basis & methodVersion 1.0 · Nov 2026Basis last checked: Oct 2026✓ Tested against worked examples

Formula

V = D/6 × (A_base + 4·A_mid + A_top) (prismoidal) Loose = V × (1 + bulking)

Standards and references

  • Prismoidal formula (earthworks)
  • BS 6031:2009 (earthworks)
  • OSHA 29 CFR 1926 Subpart P (excavation safety)

Assumptions

  • Rectangular base with the same side slope on all four sides.
  • Bulking factor entered by you; it depends on the soil type.

Inputs and units

Base lengthm
Base widthm
Depthm0.5–15
Side slope (horizontal per 1 vertical)0–3
Bulking factor%5–60
Truck capacitym³

Typical range: last column

Worked example (default values)

  • Base length20 m
  • Base width12 m
  • Depth3 m
  • Side slope (horizontal per 1 vertical)1
  • Bulking factor25 %
  • Truck capacity16 m³
Bank (in-situ) volume1,044.0 m³

Next steps

More Geotechnical calculators

Found an error? Tell us

Describe the problem briefly (the wrong value, the right one, and the reference if you have it). The page name is sent automatically.