Geotechnical

Bearing Capacity & Settlement

A foundation must not fail in shear (bearing capacity) and must not settle too much (settlement). The allowable bearing pressure is the lower of the two limits.

Bearing capacity

  • Ultimate bearing capacity is the pressure that causes shear failure of the soil.
  • Allowable = ultimate ÷ factor of safety, typically 2.5–3 in working stress design. Eurocode 7 uses partial factors instead.
  • It depends on soil strength (c′, φ′), footing width and depth, and groundwater. A water table at the base can cut the width term by about half.

Settlement

  • Immediate settlement happens as load is applied; dominant in sands.
  • Consolidation settlement develops over months or years in clays as water drains out.
  • Differential settlement between footings causes cracks; it matters more than the total value.
  • Typical limits: about 25 mm total for isolated footings on sand and about 50 mm for rafts, but the structure and finishes decide the real limit.

Choosing the foundation

  • Shallow pads and strips when good soil is near the surface.
  • Rafts to spread load and reduce differential settlement.
  • Piles when good soil is deep or loads are high; check negative skin friction in soft or fill layers.
Good to knowOn many projects the GI report gives an allowable bearing value directly. Use it, and treat calculated values as a check rather than a replacement.

Use with this guide

Found an error? Tell us

Describe the problem briefly (the wrong value, the right one, and the reference if you have it). The page name is sent automatically.