4–20 mA Loop Voltage Budget

Is there enough voltage left at a 2-wire transmitter?

Design data
V
V
Ω
Ω
m
Settings & basis
ResultPreliminary · verify before design
Voltage left at the transmitter18.3 V5.7 V dropped across 261 Ω at 22.0 mA
Within limitEnough: 7.8 V above the transmitter minimum
Cable loop resistance (both cores)10.9 Ω
Total loop resistance261 Ω
Maximum loop resistance at this current614 Ω
Maximum cable length (one way)10,045 m
HART needs at least 230 Ω in the loopMet

Conductor resistance uses IEC 60228 maximum values at 20 °C (class 2 copper: 36.0, 24.5, 18.1 and 12.1 Ω/km); hot cable routes add a few per cent. Take the lift-off voltage from the transmitter datasheet; it can be higher with a display, HART or a hazardous-area certificate. Barrier and isolator resistance comes from their datasheets.

What to verify before design ↓

Verify before using in design

  • Use the transmitter's lift-off voltage for the actual options (display, HART, Ex certificate).
  • For intrinsically safe loops, check the barrier's entity parameters as well as the voltage.
  • Check the edition of each standard that your project specification calls for.
  • Confirm with manufacturer data and the approved design before construction.
Basis & methodVersion 1.0 · Nov 2026Basis last checked: Oct 2026✓ Tested against worked examples

Formula

V at transmitter = Vsupply − I × (2 × L × r + R receiver + R barrier)

Standards and references

  • IEC 60381-1
  • IEC 60228 (conductor resistance)
  • HART Communication Protocol (FieldComm Group)
  • Transmitter and barrier datasheets

Assumptions

  • Copper conductors at 20 °C, IEC 60228 class 2 maximum resistance.
  • One transmitter, one receiver and at most one barrier or isolator in the loop.

Inputs and units

Loop supply voltageV12–36
Transmitter minimum voltage (lift-off)V
Receiver (input) resistanceΩ
Barrier or isolator resistanceΩ
Cable length (one way)m1–5000
Conductor size (copper)—
Current to check—

Typical range: last column

Worked example (default values)

  • Loop supply voltage24 V
  • Transmitter minimum voltage (lift-off)10.5 V
  • Receiver (input) resistance250 Ω
  • Barrier or isolator resistance0 Ω
  • Cable length (one way)300 m
  • Conductor size (copper)1.0 mm²
  • Current to check22 mA (fault-high margin)
Voltage left at the transmitter18.3 VEnough: 7.8 V above the transmitter minimum

Next steps

More Controls & automation calculators

Found an error? Tell us

Describe the problem briefly (the wrong value, the right one, and the reference if you have it). The page name is sent automatically.