Process & industrial

PFDs, P&IDs & Process Safety Studies

Every process plant is described by a small set of documents. If you can read a P&ID and know where the safety studies sit, you can find your way on any oil, gas, chemical or desalination project.

The key documents

  • PFD (process flow diagram): main equipment, streams and the heat and material balance.
  • P&ID (piping and instrumentation diagram): every line, valve, instrument and control loop. It is the master document for design, construction and commissioning.
  • Line list: each line number with its size, piping class, design pressure and temperature, test pressure and insulation.
  • Equipment list, instrument index and cause and effect charts (which trip closes which valve).

Reading a P&ID

  • A line number usually carries size, service code, sequence number and piping class (e.g. 6"-HC-1001-A1A-IH).
  • Spec breaks show where the piping class changes, often at a valve or flange.
  • Instrument bubbles follow ISA 5.1: letters give the measured variable and function (PT, FCV, LSHH).
  • Check the legend sheets first: symbols vary between clients. The Symbols page on this site covers the common ones.

Process safety studies

  • HAZID early in design, HAZOP on the P&IDs: a team applies guide words (no, more, less, reverse) to each node.
  • LOPA checks whether the protection layers are enough; gaps lead to safety instrumented functions.
  • Safety instrumented systems are designed to IEC 61511, with a target SIL for each function.
  • Every study action must be closed and recorded before start-up.
Good to knowOn a brownfield site, walk the line with the P&ID in your hand before you trust it. As-built drawings are often a revision behind the plant.

Use with this guide

Found an error? Tell us

Describe the problem briefly (the wrong value, the right one, and the reference if you have it). The page name is sent automatically.