Water Supply Networks
A water network has to deliver enough water, at the right pressure, to every customer at the peak hour, and still meet the fire flow, without leaking or going stale. Design sets the sizes; construction quality decides the leaks.
Design basics
- Demand from population and per-capita use, with maximum-day and peak-hour factors, plus fire flow.
- Minimum and maximum service pressures are set by the water authority; the network is modelled (e.g. EPANET) to check them.
- Loops are preferred to dead ends: they keep water moving and give two supply routes.
- Storage (ground tanks, elevated tanks) covers peaks, fire and outages.
Pipes and fittings
- Ductile iron: strong, for larger mains and high pressure; needs external protection in aggressive Gulf soils.
- HDPE: flexible, butt or electrofusion welded, good corrosion resistance; welding quality is critical.
- GRP: light, for large diameters and transmission mains; careful bedding needed.
- Valves for isolation, air valves at high points, washouts at low points, hydrants as Civil Defence requires, and thrust blocks or restrained joints at bends.
Gulf issues
- Very high per-capita demand and high summer peaks.
- Hot ground raises water temperature and lowers chlorine residual; avoid long dead ends.
- Aggressive soils and groundwater: use coatings, sleeving and cathodic protection as specified.
- Desalinated supply: water can be aggressive to cement linings and metals unless it is stabilised.