Surveying

Utility Detection & Surveys

Gulf cities are full of buried power cables, fibre, water and gas lines, and records are often incomplete. Striking a live cable or a main is one of the most dangerous and expensive mistakes on site.

Before excavation

  • Collect utility records from every owner and the authority's NOC (no-objection) process.
  • Scan the area with a cable avoidance tool (CAT and signal generator) and, where needed, ground-penetrating radar (GPR).
  • Mark detected services on the ground with the agreed colour code and record them on a drawing.
  • Utility surveys are often classified by quality levels (for example PAS 128 in the UK): records only, detection, verified by trial holes.

Trial holes and safe digging

  • Confirm critical services with hand-dug or vacuum-excavated trial pits before machine digging.
  • Keep machines away from marked services by the distance in the permit; dig by hand near them.
  • Treat every cable as live until proven otherwise; stop and report any unknown service.

Recording

  • Survey exposed services (position, depth, size, type) before backfilling and add them to the as-built drawings.
  • Share the records with the client and the utility owners; they protect the next contractor.
Good to knowScan again on the morning of the dig. Marks fade, get moved, and other contractors dig nearby overnight.

Use with this guide

Found an error? Tell us

Describe the problem briefly (the wrong value, the right one, and the reference if you have it). The page name is sent automatically.