ELV

Fire Alarm Systems

A fire alarm system detects fire early, warns people and starts the building's fire safety actions. In the region designs usually follow NFPA 72 or BS 5839-1 with EN 54 listed devices, plus the local civil defence requirements.

Conventional or addressable

  • Conventional: devices are wired in zones. The panel knows which zone is in alarm, not which device. Suits small buildings.
  • Addressable: every device has an address on a loop, so the panel shows the exact location. Standard for most commercial projects.
  • Loops: wired as a loop (Class A / return path) with short-circuit isolators, so one cable fault does not lose the whole loop.
  • Cable: fire-resistant cable (standard or enhanced grade per BS 5839-1) fixed with metal clips, not plastic ties alone.

Main devices

  • Detectors: optical smoke, heat (fixed or rate-of-rise), multi-sensor, beam, aspirating (ASD) and flame.
  • Manual call points on escape routes and at exits.
  • Sounders, beacons and voice alarm to warn occupants. Visual alarms are needed where people are deaf or the area is noisy.
  • Interface modules to monitor sprinkler flow switches and to control fans, dampers, lifts and doors.

Cause & effect

  • A cause & effect matrix lists every input (detector zone, flow switch, call point) against every output (sounders, AHU shutdown, damper close, lift homing, door release, PA message).
  • Agree the matrix with the fire consultant and authority before programming the panel.
  • Witness every line of the matrix during commissioning and keep the signed copy in the O&M manual.

Typical point detector coverage (flat ceiling)

StandardSmoke detectorHeat detector
BS 5839-1Max 7.5 m from any pointMax 5.3 m from any point
NFPA 72Nominal 9.1 m (30 ft) spacingPer listed spacing of the detector
Good to knowKeep smoke detectors at least 1 m from supply air diffusers (BS 5839-1). Air flow can blow smoke away from the detector and delay the alarm.

Use with this guide

Found an error? Tell us

Describe the problem briefly (the wrong value, the right one, and the reference if you have it). The page name is sent automatically.