Environmental

Dust, Air Quality & Noise Control

Dust and noise cause most complaints from neighbours, and in the Gulf dry ground and strong winds make dust a daily issue. Both are easier to prevent at source than to fix after a complaint.

Dust

  • Main sources: earthworks, haul roads, stockpiles, cutting and grinding, and wind over bare ground.
  • Controls: water spraying or dust suppressants on roads, speed limits, covered trucks, wheel washes, covered or wetted stockpiles, cutting with water or extraction.
  • Stop dusty work in strong winds (a wind speed trigger in the CEMP helps).
  • Monitor PM10 at the boundary where the permit requires it; compare with the permit limits.

Noise

  • Levels add logarithmically: two equal sources add 3 dB; doubling the distance from a source takes off about 6 dB (see the calculator).
  • Choose quieter equipment, keep it maintained, turn engines off when idle, and place generators and compressors away from receivers.
  • Use barriers or site hoarding close to the source or the receiver; agree working hours, especially for night work.
  • Measure at the receiver with a calibrated meter and log the results.

Other air emissions

  • Generators and plant: maintain engines, avoid oversized lightly loaded generators, connect to the grid early.
  • No burning of waste on site.
  • Control fumes from welding, paints and solvents in enclosed areas (also a health issue).
Good to knowKeep a water bowser on site from day one. The first dust complaint usually comes in the first week of earthworks.

Use with this guide

Found an error? Tell us

Describe the problem briefly (the wrong value, the right one, and the reference if you have it). The page name is sent automatically.