ELV

Fiber Optics: Types Explained

Optical fiber carries light in a thin glass core. The two families are single-mode (small core, long distances) and multimode (larger core, short distances inside buildings and data centres).

Single-mode vs multimode

  • Single-mode (OS1a/OS2): 9 µm core, yellow jacket, 1310 and 1550 nm lasers. Distances of 10 km and more. Used for campus backbones, outside plant, FTTH and telecom.
  • Multimode (OM1–OM5): 50 or 62.5 µm core, 850 and 1300 nm sources. Used inside buildings and data centres up to a few hundred metres.
  • Single-mode cable is not more expensive than multimode, but its optics (transceivers) usually cost more.
  • Never mix single-mode and multimode in one link: the loss is very high.

Connectors and polish

  • LC: small, the most common today. SC: push-pull, common in FTTH and older panels. MPO/MTP: 8, 12 or 24 fibers in one connector for high-speed data centre links.
  • UPC polish has a blue body (single-mode); APC polish is angled 8° with a green body and lower reflection, used in FTTH and video.
  • Never connect APC to UPC: the air gap causes high loss and can damage the end faces.

Cable construction

  • Tight buffered cable for indoor use, easy to terminate.
  • Loose tube gel-filled or dry cable for outdoor and duct use; armoured where rodents or direct burial are expected.
  • Fiber colours follow TIA-598: blue, orange, green, brown, slate, white, red, black, yellow, violet, rose, aqua.

Fiber types at a glance

TypeCoreJacket10 Gb/s reach
OM162.5 µmOrangeAbout 33 m
OM250 µmOrangeAbout 82 m
OM350 µmAquaAbout 300 m
OM450 µmAqua / violetAbout 400 m
OM550 µmLime greenAbout 400 m, plus SWDM
OS29 µmYellow10 km and more
Good to knowFor a new building backbone, many designers now install single-mode only, or a hybrid cable with OS2 and OM4, so the cabling outlives several generations of equipment.
Found an error? Tell us

Describe the problem briefly (the wrong value, the right one, and the reference if you have it). The page name is sent automatically.