ELV

CCTV & Video Surveillance

Modern CCTV uses IP cameras powered by PoE, recording to an NVR or a video management system (VMS). Good design starts from what each camera must achieve: detect, observe, recognise or identify.

Design steps

  • Define the purpose of each camera, then choose the lens and resolution to reach the required pixel density at the target distance.
  • Check lighting: use IR or white light for night images, and wide dynamic range (WDR) for entrances facing bright sun.
  • Use outdoor housings rated at least IP66, and IK10 where there is vandal risk.
  • Follow the local authority requirements for camera locations, resolution and retention where they apply.

Recording and network

  • H.265 compression roughly halves the storage of H.264 for similar quality.
  • Storage = cameras × bitrate × recording time. Use the CCTV storage calculator in this site.
  • Put cameras on a separate VLAN, change default passwords, update firmware and synchronise time with NTP.
  • Choose ONVIF conformant cameras if the VMS and camera brands differ.

DORI pixel densities (EN 62676-4)

LevelPixels per metreWhat you can do
Detect25 px/mSee that a person is present
Observe62 px/mSee what a person is doing
Recognise125 px/mRecognise a known person
Identify250 px/mIdentify an unknown person beyond doubt
Good to knowTest every camera at night before handover. Many sites look good at noon and show only noise and IR glare after dark.

Use with this guide

Found an error? Tell us

Describe the problem briefly (the wrong value, the right one, and the reference if you have it). The page name is sent automatically.