Design & engineering

ELV & Low-Current Systems Engineer

Designs, installs and commissions the low-current systems in a building: fire alarm, PA/VA, CCTV, access control, structured cabling, fiber, AV, BMS integration and smart building networks.

Career path

  1. 1
    ELV site / design engineerLayouts, cable schedules, installation supervision, testing
  2. 2
    Senior ELV engineerFull system design, submittals, integration with other trades
  3. 3
    ELV / ICT lead or managerMulti-system packages, vendors, authority approvals
  4. 4
    Smart building / ICT consultantStrategy, specifications and digital building design

Core skills

NFPA 72 / BS 5839Cause & effectStructured cabling (TIA-568)Fiber splicing and testingIP networking and VLANsCCTV and VMS designAccess control integrationAutoCAD / Revit

Recommended certificates

CertificateIssued byWhen
FOA Certified Fiber Optic Technician (CFOT)Fiber Optic AssociationEarly career
CompTIA Network+CompTIAEarly career
Vendor certifications (fire alarm, CCTV and access control brands)ManufacturersEarly career
BICSI Installer / TechnicianBICSIMid-career
NICET Fire Alarm Systems (Level II–III)NICETMid-career
AVIXA CTSAVIXAMid-career
Cisco CCNACiscoMid-career
BICSI RCDDBICSISenior
Career tipLearn IP networking. Almost every ELV system now runs on the network, and engineers who can talk to the IT team about VLANs and PoE are in demand.

Interview questions

What is the difference between single-mode and multimode fiber?

Single-mode has a 9 µm core, uses lasers at 1310/1550 nm and runs for kilometres. Multimode has a 50 µm core, uses 850/1300 nm sources and is for short runs inside buildings and data centres.

How do you accept a fiber link?

Inspect and clean the end faces, run a Tier 1 loss test at two wavelengths with the one-jumper reference, compare with the calculated loss budget, and add OTDR traces if the specification asks for Tier 2.

Why must escape doors use fail-safe locks?

So that people can always leave: on power loss or fire alarm the door releases. The fire alarm release must be hard-wired, not only through software.

Check each certifying body's website for current eligibility and exam requirements.